Select Page

UOT Bicycle Chain Link Identification & Design Manufacturing Processes Discussion

Question Description

I’m working on a mechanical engineering report and need a sample draft to help me study.

You need to identify and determine the parts’ design parameters in your projects such as size, speed, operating temperature, operating environment, applied load or stress, rigidity, cost, reliability, tolerances, materials, processing therefore, you should consider an average real-life application of each part in your project set and then estimate the parameters. The required information can be acquired via library methods, relevant codes/standards/regulations, and digital methods, which must be cited in your report (provide the references in your report). Computer modeling/finite element analysis is not required for this project.

Therefore, a report detailing the design procedure and analysis must be submitted. The report should excluding the front matter and appendices. All of the following are suitable for inclusion in the report.

? aspects of design philosophy

? aspects of the PEO Code of Ethics

? detailed drawings, free body diagram, plans

? analysis to estimate the strength, the state of stress, stress concentration areas, factor of safety

? if cycling load is applied and fatigue failure is a possibility, consider the required design parameters and methods

? failure analysis and discussion

? preliminary sketches (Appendix)

You could choose any material for the chain link, just ensure it can be used on the bike.

Include :

introduction

Analysis

Calculation/ evaluation

ConclusionIntroduction Analysis

"Place your order now for a similar assignment and have exceptional work written by our team of experts, guaranteeing you "A" results."

Order Solution Now