Select Page

ETD 1320C The University of Tampa Draw the Closed End Wrench Autocad Task

Question Description

  • Draw a closed end wrench
  • Set UNITS as shown
  • Length Type = DECIMAL
    • precision=0.00
  • Set LIMITS as shown
    • Lower Left = (0,0), Upper Right =(11,9)
  • Create LAYERS outlined below (these may be different than what is shown in our Class Standard).
  • Make LINEWEIGHT as shown in the table below.
  • Draw figure as shown in PDF provided in the MIDTERM folder keep orientation Landscape.
  • Draw figure in Model space to precise dimensions shown in PDF.
  • Use dimensions provided to draw figure but do not add dimensions to drawing.
  • Fill out the title block fully and completely.
  • Create (1) Viewport in layout to show figure drawn in model space. Make sure your viewport is in the correct layer per our standard.
  • Submit both drawing and PDF, Both must be submitted. If PDF or DWG file is missing you will be deducted 50 pts (half the possible points) leaving you with a maximum of 50 possible points for this portion of the test. So please submit both. Also, make sure you submit DWG file with the correct extension (drawing.dwg).
  • "Place your order now for a similar assignment and have exceptional work written by our team of experts, guaranteeing you "A" results."

    Order Solution Now