ETD 1320C The University of Tampa Draw the Closed End Wrench Autocad Task
Question Description
Draw a closed end wrench
Set UNITS as shown
Length Type = DECIMAL
Set LIMITS as shown
- Lower Left = (0,0), Upper Right =(11,9)
Create LAYERS outlined below (these may be different than what is shown in our Class Standard).
Make LINEWEIGHT as shown in the table below.
Draw figure as shown in PDF provided in the MIDTERM folder keep orientation Landscape.
Draw figure in Model space to precise dimensions shown in PDF.
Use dimensions provided to draw figure but do not add dimensions to drawing.
Fill out the title block fully and completely.
Create (1) Viewport in layout to show figure drawn in model space. Make sure your viewport is in the correct layer per our standard.
Submit both drawing and PDF, Both must be submitted. If PDF or DWG file is missing you will be deducted 50 pts (half the possible points) leaving you with a maximum of 50 possible points for this portion of the test. So please submit both. Also, make sure you submit DWG file with the correct extension (drawing.dwg).
"Place your order now for a similar assignment and have exceptional work written by our team of experts, guaranteeing you "A" results."
